Skip to content
VARSHA INDUSTRIES

Industry

Rubber components for general engineering

Made-to-drawing moulded components for machine builders, job shops and maintenance teams — from a single replacement part to scheduled monthly quantities.

Catalogued parts
100
Compounds used
7
Custom work
To drawing or sample

What we typically supply into this sector

  • Custom moulded parts to drawing or sample
  • Machine levelling mounts and feet
  • Bumpers, buffers and stops
  • Cut gaskets, cords and profiles

Compounds we use here

Nitrile (NBR)−30 °C to +110 °CThe workhorse oil-resistant elastomer. Excellent resistance to petroleum oils, hydraulic fluids, greases and diesel, with good abrasion and compression-set behaviour at a modest cost.EPDM−45 °C to +140 °CThe choice wherever water, steam, weather or ozone are involved. EPDM ages outdoors almost indefinitely and handles hot water and low-pressure steam that would destroy nitrile.Viton (FKM)−20 °C to +230 °CThe premium fluoroelastomer for aggressive chemicals and sustained high heat. Specified where a nitrile part is failing early and downtime costs more than the seal.Neoprene (CR)−35 °C to +120 °CThe balanced all-rounder. Moderate oil resistance combined with genuine weather resistance and inherent flame retardance — no other single compound covers that spread as cheaply.Natural Rubber−50 °C to +80 °CUnmatched resilience, tear strength and dynamic fatigue life. Still the correct choice for shock and vibration work wherever oil is not present.PTFE / Teflon−200 °C to +260 °CNot an elastomer but a fluoropolymer, used as a bonded facing over a rubber backing. It gives a chemically inert working face while the rubber underneath supplies the flex.Polyurethane−30 °C to +80 °CExceptional abrasion resistance and load capacity — several times the wear life of conventional rubber on sliding or impact duty.

Catalogued components for general engineering

See all 100 components

Other industries we serve

Pumps & ValvesWinery & Food ProcessingChemical & ProcessRopeways & Material HandlingElectrical & SwitchgearAutomotive & EnginesSurface Coating & PlatingTextile & PolyesterMarine

Send a drawing, a sample, or just a photo of the worn part.

We will identify the compound, quote the tooling and get a first sample to you. No drawing needed — a measured sketch or the old component is enough to start.

Request a quotation WhatsApp us