Manufacturer since day one — you deal directly with the plant, not a marketplace
Knowledge base
Six guides covering the questions that come up most often. Written to be useful whether or not you ever order anything from us — if they save you a failed batch, they have done their job.
A mount only isolates above a frequency ratio of 1.41. Below that it amplifies vibration. Here is the calculation that tells you which side of the line your machine sits on.
Read the articleNitrile and EPDM look identical and cost about the same. Put each in the other application and it fails within weeks. A practical guide to telling them apart and specifying correctly.
Read the articleMost replacement rubber components are ordered from a worn sample, not a drawing. Here is exactly what to measure, photograph and record so the first sample comes back right.
Read the articleA bonded mount that debonds is more dangerous than no mount at all. The four causes of bond failure — surface preparation, adhesive system, cure and design — and what to check.
Read the articleMasking plugs that shrink, harden or stick to the workpiece after one oven pass are the wrong compound. How to choose plugs that last dozens of cycles.
Read the articleInjection moulding wins on unit cost at high volume and loses badly at low volume because of tooling. Where the crossover actually falls, and why compression moulding suits replacement parts.
Read the articleWe will identify the compound, quote the tooling and get a first sample to you. No drawing needed — a measured sketch or the old component is enough to start.